Maro Publications

Blown Film

Notes

*5/2/2012

Maro Topics

Comments

Articles with Abstracts

Articles without Abstracts

Books.htm

Patents with Abstracts

Patents without Abstracts

Extrusion

Film

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx 

Notes

2. “One of the most common methods of film manufacture is Blown Film (also referred to as the Tubular Film) Extrusion. The process involves extrusion of a plastic through a circular die, followed by "bubble-like" expansion. The principal advantages of manufacturing film by this process include the ability to:

Produce tubing (both flat and gussetted) in a single operation

Regulation of film width and thichness by control of the volume of air in the bubble, the output of the extruder and the speed of the haul-off

Eliminate end effects such as edge bead trim and non uniform temperature that can result from flat die film extrusion

Capability of biaxial orientation (allowing uniformity of mechanical properties)

Blown Film Extrusion can be used for the manufacture of co-extruded, multi-layer films for high barrier applications such as food packaging.”

(Plastipedia, Blown Film, 5/2/2012)

------------------------------------------------------------

1. “Plastic melt is extruded through an annular slit die, usually vertically, to form a thin walled tube. Air is introduced via a hole in the centre of the die to blow up the tube like a balloon. Mounted on top of the die, a high-speed air ring blows onto the hot film to cool it. The tube of film then continues upwards, continually cooling, until it passes through nip rolls where the tube is flattened to create what is known as a ' lay-flat' tube of film. This lay-flat or collapsed tube is then taken back down the extrusion ' tower' via more rollers. On higher output lines, the air inside the bubble is also exchanged. This is known as IBS (Internal Bubble Cooling).

The lay-flat film is then either kept as such or the edges of the lay-flat are slit off to produce two flat film sheets and wound up onto reels. If kept as lay-flat, the tube of film is made into bags by sealing across the width of film and cutting or perforating to make each bag. This is done either in line with the blown film process or at a later stage.

Typically, the expansion ratio between die and blown tube of film would be 1.5 to 4 times the die diameter. The drawdown between the melt wall thickness and the cooled film thickness occurs in both radial and longitudinal directions and is easily controlled by changing the volume of air inside the bubble and by altering the haul off speed. This gives blown film a better balance of properties than traditional cast or extruded film which is drawn down along the extrusion direction only.”

(Plastipedia, Blown Film, 5/2/2012)

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

In this day of overworked technical people, keeping up is nearly impossible.  Maro's mission is to help keep up in as little time as possible.  Bookmark this page and check it often.  You will be surprised what can be picked up in just a few moments spent each day.

These pages list the links as they are found.  Some will abstracted and added to Maro Topics. (RDC 2/7/2012)

 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

Roger D. Corneliussen
Editor
www.maropolymeronline.com

Maro Polymer Links
Tel: 610 363 9920
Fax: 610 363 9921
E-Mail: cornelrd@bee.net  

***********************************

Copyright 2012 by Roger D. Corneliussen.
No part of this transmission is to be duplicated in any manner or forwarded by electronic mail without the express written permission of Roger D. Corneliussen
**************************************

* Date of latest addition; date of first entry is 5/2/2012.